SignaMax 065-7714HSFPTB Manuel d'utilisateur télécharger pdf (Page 157)

Hardened Managed Ethernet Switch

User’s Manual 156

Other Protocols

GVRP, IGMP Snooping, NTP

GVRP

GVRP:

1. Command Mode: Configure mode

Logon to Configure Mode (Configure Terminal Mode).

The switch_a(config)# prompt will show on the screen.

switch_a(config)#

2. Usage:

Use set gvrp enable bridge command to enable (set) and set gvrp disable

bridge command to disable (reset) GVRP globally for the bridge instance.

This command does not enable/disable GVRP in all ports of the bridge. After

enabling GVRP globally, use the set port gvrp enable command to enable

GVRP on individual ports of the bridge.

3. Command Syntax:

set gvrp enable bridge GROUP

set gvrp disable bridge GROUP

GROUP Bridge-group ID used for bridging.

4. Example:

The following example globally enables GVRP to bridge GROUP (1):

switch_a(config)#set gvrp enable bridge 1

switch_a(config)#

Dynamic VLAN creation:

1. Command Mode: Configure mode

Logon to Configure Mode (Configure Terminal Mode).

The switch_a(config)# prompt will show on the screen.

switch_a(config)#

2. Usage:

Use set gvrp dynamic-vlan-creation enable bridge command to enable

and set gvrp dynamic-vlan-creation disable bridge command to disable

dynamic VLAN creation for a specific bridge instance.

3. Command Syntax:

set gvrp dynamic-vlan-creation enable bridge GROUP

set gvrp dynamic-vlan-creation disable bridge GROUP

GROUP Bridge-group ID used for bridging.

1 2 ... 152 153 154 155 156 157 158 159 160 161 162 ... 177 178

Pas de commentaire

SignaMax 065-7714HSFPTB Manuel d'utilisateur Page 157